01 / GUIDE

Read the pressure convention

Specify whether a requirement is absolute pressure or boost above ambient. Keep units consistent across the sensor label, controller configuration and project request.

02 / GUIDE

Record the transfer data

Record the part number and manufacturer calibration data. A voltage-output sensor needs the correct voltage-to-pressure relationship in the ECU; the pressure range alone does not define that relationship.

03 / GUIDE

Check the physical and electrical interface

Confirm the pressure port, mounting, connector pinout and supply requirements against the sensor data sheet. Similar housings can contain different sensors.

04 / GUIDE

Prepare a calibration review

Share the sensor label, calibration sheet, ECU model and intended pressure range. Initial readings should be checked by the installer before the setup is used under load.

Checklist & example

  • Vehicle: market / year / model. Engine: code and any swap.
  • Original ECU: part number. Target ECU: model and hardware revision.
  • Wiring: both connector faces and pinout. Retained functions: list individually.